Better discord themes railgun
Cut 12, -foot strands of both the red and black copper wires.
Repeat step 5 60 times, and leave two capacitors on their boards. Desolder the capacitor from the board by using the soldering iron. Repeat steps until all circuit boards are removed and discharged. Locate capacitor on the board and discharge it by placing flathead screwdriver on both positive and negative prongs. Remove the circuit board from the camera center. Open the disposable camera casing and remove the center. Hypothesis: If a capacitor bank of V capacitors ranging from 80f to f was built from 60 individual capacitors, then it should harness energy effectively to a point of V, which could later be used to fire a projectile. The purpose of this experiment is to create and harness enough energy to later attach to a railgun and fire a projectile. The gun also takes immense energy to launch the projectile, even in small models. The rails of the gun are almost always destroyed by the firing of the gun, creating a one-shot deal for the gun, before it must be shutdown and repaired. However, the railgun also poses many disadvantages in its design. This gives it many military advantages, because if there are no incendiaries to fire at, it make a ship less likely to be sunk. The railgun differs from its ancestors due to its lack of requiring an incendiary to launch a projectile. Long-ranged weaponry spans through the ages into even prehistoric times, from the spear and javelin, to the bow, later to the crossbow, next to the musket, after, the rifle, and now it seems to a new weapon, the railgun. This futuristic ideal that the world is striving for can also be seen in the field of weaponry. The cell phone is getting smaller while still becoming more advanced. Introduction: Purpose: In our modern age of technological advancement, wondrous things are being invented to advance our way of seeing the world. Though data in this experiment is almost nonexistent, this experiment is a vital stepping stone to the end goal of the entire project. The goal of this experiment is to build a bank capable of holding V. It holds the energy required to fire the projectile.
The capacitor bank is, in essence, the battery of the gun.
Abstract: This experiment outlines the construction of a vital component of a railgun, the capacitor bank.